We are a single source supplier of coatings for wind turbines - from tip to toe.
A quick dry, corrosion resistant gloss enamel specially formulated for finishing metal products.
A two component, HAPs free, low VOC, high solids, fast curing epoxy primer/finish.
A low VOC, two component acrylic polyurethane high performance finish coat with excellent gloss and colour retention on exterior exposure, for use over correctly prepared primed surfaces.
Specifically designed be embedded in the INTERCRETE range of cementitious coatings to provide a highly flexible impermeable seal over ‘live’ cracks and expansion or construction joints in waterproofing applications.
Intercrete 4872 is a permanently elastomeric composite tape exhibiting over 600% elongation which enables rapid application of the INTERCRETE range.
Provides excellent weathering resistance and is highly tolerant of a wide range of chemicals and is impermeable to water under 10 bar hydrostatic pressure (100m head of water).
Specifically designed to be broadcast into the surface of INTERCRETE coatings to aid curing and provide a durable slip and abrasion resistant finish.
INTERCRETE 4854 grit provides a hard-wearing, slip-resistant surface which will provide ultimate protection against foot traffic, wheelchair use, impact from heavy objects and attack from the elements.
Supplied as a 100mm wide preformed strip on siliconised release paper, the backing strip is simply removed upon application. Non-toxic and approved for use in contact with potable water, Intercrete 4874 is ideal for use in a wide range of waterproofing applications, such as reservoirs, water tanks, roof slab and projects in enclosed locations where it is not suitable to use solvent-based or hot welded products
Supplied in two grades for the reinforcement of the Flexcrete range of cementitious mortars and coatings:
INTERCRETE SCRIM: Particularly suited for general reinforcement over large areas of cracking/crazing or weak/friable substrates, particularly insulation, to provide increased tensile strength and impact resistance.
INTERCRETE EDGE SCRIM: For localised reinforcement over joints or cracks to provide increased tensile strength. Can also be used over welds or edges of steel sections to help maintain correct film thickness. Self-adhesive.
Specifically designed as a general reinforcement for elastomeric cementitious coatings such as Intercrete 4842, particularly on roofs or other areas of cracked concrete where further movement is possible. It provides additional toughness to the film whilst still maintaining a high degree of flexibility
Specially designed for easy embedment in the Intercrete range of decorative protective coatings to ensure continuity of a seamless finish over cracks or joints, and at junctions between dissimilar substrates. Available in two grades, the Light Duty grade may be used to cover static cracks and joints, whereas for larger cracks and joints which are subject to movement, Heavy Duty grade is recommended. By introducing Intercrete 4878 into the applied membrane, a fully waterproof and permanently flexible finish is assured. Intercrete 4878 is non-degrading and is suitable for both internal and external applications.
Supplied in two grades for the reinforcement of the Intercrete range of fluid applied membranes. It is particularly suited for the reinforcement of Intercrete 4845 used in pitched and flat roof waterproofing where it greatly enhances tensile strength and tear resistance to increase cohesive strength of the composite membrane to accommodate cracks in roofing substrates. It is also used to reinforce membranes in situations where a multi-crazed or cracked substrate must be treated, or where there is a need to provide an additional defence against mechanical damage in high traffic environments.
Corrosion & fire protection coatings for buildings
Coatings for abrasive and corrosive environments
Coatings & fire protection for upstream oil & gas
Coatings & fire protection for downstream oil & gas